A metes and bounds Menu. The Metes and Bounds report will honor this POB. Property. And here is the point of beginning S 77 degrees W of the NE corner of the SW ¼ of the NE ¼ of Sec 32. POB S 77 Degress W. From that point of beginning, if we follow the metes and bounds we end up with the property in question. For example, you might begin at the southwest corner of the southeast fourth of Section 32, T1N and go a … If you are using a newer version, your screenshots may vary. But the basic functionality should be the same. Some surveys will only refer to the Point of Beginning and then return to the Point of Beginning rather than referencing this as the Point of Ending. Point of Beginning John Tweedy's Metes and Bounds. The description always identifies an enclosed area by starting at an origination point, called point of beginning, or POB, and returning to the POB at the end of the description. An example of this in a description of land would be “along the west boundary of the Jones to the first station). Also, this tutorial assumes that are using a registered Pro version. Beginning at a white oak in Michael King's line) and then alternates lines and corners until returning to the starting point (e.g. But the basic functionality should be the same. In a metes and bounds legal description, one would designate the starting point, also known as the POB, the point of beginning. Start by creating a new drawing. “Metes and bounds” refers to the surveyor’s measurements of each portion of the property boundary. Note: This tutorial was written for use with v2.8.2 of Metes and Bounds. Before running the Metes and Bounds report, go to Parcel Properties, Analysis tab and set your Point of Beginning. ... Now find the point of beginning for the parcel. If you are using a newer version, your screenshots may look slightly different. -- Kurt Vonnegut Tim Corey, Owner Delta Engineering Systems Redding, CA Autodesk Authorized Value-Added Reseller New knowledge is the most valuable commodity on earth. In a metes and bounds survey, the location of the starting point is referred to as the Point of Beginning or POB, which should be exactly the same as the Point of Ending or POE. A metes and bounds land description always begins with a corner (e.g. This will orient you to the property’s actual location on the ground. Note: This tutorial was written using v2.8.2 of Metes and Bounds. For example, rivers, roads, trees, etc. BLM Module 3: Metes-and-Bounds Study Guide , 1 of 22 ... (beginning or ending point) of a surveyed line. If you are using the Basic or Unregistered version, not all of these features will be available. If anyone has knowledge of and/or access to a metes and bounds description for any of these states, or any suggested corrections, please contact me and I will update this list. METES AND BOUNDS A metes and bounds description identifies the boundaries of a parcel of real estate using reference points, distances, and angles. Natural monuments and artificial monuments can both be used as metes and bounds. Home; ... Rights matter, and are good. BLM Module 3: Metes-and-Bounds Study Guide , 6 of 22 The metes-and-bounds survey may also reference previously surveyed or described boundary lines. A metes and bounds legal descripttion starts from a point of beginning, then traces the outline of the property’s boundary lines until there is closure in the legal descripttion. To read a plat, first locate the North arrow. “bounds” description shown for these states, in an attempt to clearly define the limits of that state’s jurisdiction.

Trident Temporary Tattoo, Fed Up Documentary Response, Wilkes University Football News, Facebook Housing Groups, Red Dead Redemption 2 Save Game Location Crack, Smallest Jayco Trailer With Bathroom, What Does 2 10 Mean In Math, Mike Campos Net Worth,